USB CABLE CONNECTOR
The connector drawings and pin-outs below are examples of the 2 most common found on motherboards currently. Please refer to your motherboard's manual or your motherboard's manufacturer to be sure of the pin-out for your USB connector.

Example 1
Example 2
1 USB Power
2
USB Power
(or VCC or +5V)
(or VCC or +5V)
3 P -
4
P -
5 P +
6
P +
7 GND
8
GND
9 (empty pin)
10
GND
1 USB Power
10
GND
(or VCC or +5V)
8
GND
3 P -
6
P +
5 P +
4
P -
7 GND
2
USB Power
9 (empty pin)
(or VCC or +5V)

If your USB header does not match either of these configurations, please check your motherboard manual. The following shows you how to rewire the Easy USB if necessary for some USB headers. Please note that while this has worked for some customers we do not guarantee that this will work for your motherboard. This is just one alternative to consider, if you are not comfortable with making these modifications please do not attempt to do so. You can contact Antec's Technical Support Department for further assistance.

Wire Color Code
COLOR: CONNECT TO:
RED,ORANGE POWER, VCC, SVCC, +5V
WHITE, YELLOW P-, DATA-, SBD-
GREEN, GREY

P+, DATA+, SBD+

BLACK, BLUE, BROWN GROUND, GRND, GND

1.) Determine which wires you need to remove in order to rewire your plug to match the USB pinouts on your motherboard (refer to your motherboard manual). Working on one connector at a time, use a very small flathead screwdriver or similar tool to lift up on the black tab located beside the gold posts (squares). This will allow you to easily slide out the pins from the USB plug.
2.) Working carefully so as not to damage the wires, connectors, or pins, slowly remove the pin from the connector. Repeat these steps for each wire you need to change.
3.) Working carefully so as not to damage the wires, connectors, or pins, slowly reinsert the pin into the correct slot of the connector then snap closed the black tab that was lifted in step 1. Repeat these steps for each wire you need to change.